The D SERIES-RLC10 is a rotary remote level
control that provides user adjustment at single or multiple
locations. Optical encoder
technology allows continuous knob rotation with a comfortable adjustment rate and long-term trouble-free and noise-free operation. These controls directly connect to any RDL VCA
and OEM equipment with 0 to 10 Vdc ramp inputs.
A single RLC10 may be connected to a ramp-controlled VCA
using a single-pair shielded audio
cable or unshielded cable. A rear-panel switch configures the control as the MASTER
. The MASTER
mode causes this control to drive the 0 to 10 Vdc ramp output and to monitor its pulse terminals in case any other RLC10 controls are connected.
As many as nine additional RLC10 controls may be wired in parallel with the MASTER
control using UTP cable (CAT5
or equivalent). The rear-panel MODE switch on each additional remote control is set to SLAVE mode.
Operation is the same for a single control, or for each control connected in a multiple
control point installation. The 0 to 10 Vdc ramp voltage
is incremented up or down when the front-panel knob is rotated. Acceleration is provided so the rate of change is faster when the knob is rotated more rapidly, yielding a responsive feel and rapid elimination of acoustic feedback
. The LED
ring display encircling the control knob operates as a virtual pointer. When an RLC10 is not being adjusted, its display switches to a dim intensity to avoid being a visual distraction. The display returns to a bright intensity during adjustment.
In the event of power
loss, internal non-volatile memory stores the last level
value. When power
is restored, the 0 to 10 V output will return
to the operating level
present when power
RLC10 controls set to the SLAVE MODE may be connected to an RDL RU-VCA2A
, utilizing the VCA
as the ramp generator. This connection is also possible with OEM equipment accepting open-collector pulses that are compatible with the RLC10 output pulse rate and width.
The RLC10 controls are constructed on a steel frame. The electronics are fully protected within the rear enclosure
. Connections are made through a rear panel detachable terminal block.
All the D SERIES-RLC10 features combine to make it the ideal choice for single point or multiple
location remote level
control in high quality systems. Use them with any RDL VCA
module, or side-by-side with other RDL remote accessories as part of a complete audio